Completed rudder pedals and plumbing some of the in-cockpit brake lines. Because we are using TS Flightline brake lines, we had to enlarge one of the holes in the rudder pedal assembly middle support bracket to pass the brake lines through.
Realized that the rudder cables were in backward (forward end was at the tail ). The ends of the cable are different. Had to drill out several rivets where the cable exits the fuse near the tail to swap the cables end for end.
Found a couple places where we missed putting in some rivets. Luckily they were pretty easy to get to.
Attached the rudder cable anti-rub tubing to the center fuse using 4 adell clamps. It was especially difficult because there is very little room to get fingers and wrenches in there.
12 hours (2 people x 6 hours each).
